Skulls

[zpro1]

I started inking on some bristol board and here's the results. Its been awhile since I've done this. I decided to use a brand new nib on this piece and it started ripping up the paper because the nib was soo sharp. :confused: I forgot to fill a test page up with inked lines from this new nib. I also forgot to use the backside of the page because that side is much smoother than the front to ink on.
http://i170.photobucket.com/albums/u246/zpro1/skullside.jpg

Here's one more. Front view

http://i170.photobucket.com/albums/u246/zpro1/skullfront.jpg

http://zpro1.deviantart.com/

[di.straido]

Hi zpro1... good job man. The lines are very precise and the textures are nice too... congrats!!!

[BKMDog]

Yes, but for the most part, they're all the same weight. While I agree that this is clean, sharp and shows a good deal of control, more varied line weights in the right places will ad form and give a better sense of the play of light across the surface.

[zpro1]

Thanks for the replies. Any inkers out there let me know or give me a hint on some specific areas to increase the line widths. Should the widths be thicked were I already have them a little thicker already. Its easier for me to see the faults in others than it is in my own art at times. Well most of the times. :whistlin:

zpro1